端面铣床的构成：
1. 床身:端面铣床床身分为双矩形导轨和一矩一V合组形导轨两种,床身导轨面都经过超音频淬火处理,深度为3-5毫米,硬度为HRC-52.耐磨性能好,使用寿命长.
2. 工作台:工作台采用优质耐磨铸铁铸造而成，精加工后，采用手工铲刮与导轨面配铲而成。工作台的进给采用变频器，实现无级变速。
3.立柱：立柱的导轨是采用一高一矮两条矩形导轨组合而成。其高导轨高出矮导轨55毫米，结合面积大，稳定性能高，刚性好。采用超音频淬火处理，硬度耐磨性能好。工件高度不受机床限制，可垂直上下铣削。
4.横向床身：横向床身是在水平面上垂直与主床身，沿垂直与主床身中心线在水平面作前后运动。具有铣削宽广的特点。由减速电机带动丝杠螺母运动。
5. 主轴：拥有独立进给系统，进给速度由变频器控制，可根据工件不同材质，调节镗孔(钻孔)速度。 其中自动进给可选300/460/600mm，手动微调为150mm。
Face milling machine consists of the following sections
Lathe bed ：face milling machine lathe bed is divided into double rectangular guideway and a rectangular
and a V composite guideway，Lathe bed guide surface get through super audio quenching processing，the depth is3-5mm，the hardness is HRC-52，the machine has excellent wearability and long life.
Worktable:worktable is made of high quality cast iron , after finishing, adopts manual shovel
scraping and guide surface scraping，worktable feed adopts frequency converter, achieve stepless variable speed.
Column：column guide adopts two rectangular guideways(one is high,the other is short). the high guideway
is 55mm higher than the short one, the large guide surface, high stability, good rigidity.it Is made
of super audio quenching treatment, the hardness wear-resisting performance is good. Workpiece height without being limited by the machine, vertical milling,
it can work in vertical way(up and down)
Horizontal lathe bed:Horizontal lathe bed is vertical with the main lathe bed in the horizontal plane,
movement(front and back) with the main lathe bed center line in the horizontal plane along the vertical. Milling is broad,the leadscrew nut is driven by a speed reducer
Spindle has independent feed system, feed speed is controlled by frequency converter, according to
different workpiece material to adjust the speed of boring (bore). Which automatically feed optional
is 300/460/600 mm, manual fine tuning is 150 mm
注：联系我时，请说是在“傲立机床网”上看到的，谢谢！
